Modelling and Simulation of Reinforced Concrete Bridges with varying percentages of Shape Memory Alloy Rods

Document Type : Original Article

Authors

1 Ph.D. Department of Civil Engineering, Kwara State University, Malete, Nigeria

2 Prof. Department of Civil Engineering, University of Ilorin, Ilorin, Kwara State, Nigeria

Abstract

Earthquakes constitute a major problem for mankind resulting in loss of lives and structures. Smart structural materials such as Shape Memory Alloy (SMA) suppress the structural vibration in a structure by adjusting the dynamic performance of the structure. SMA rods are unique for their shape memory effect and super elasticity and have been used as structural reinforcement for earthquake retrofits. This research focused on investigating the appropriate percentage of shape memory alloy and steel reinforcements for the least deflection in the column-capping beam of a 3-span composite Matsurube Bridge in Japan subjected to seismic load. Five different earthquake scenarios were used to obtain the best combination of steel and SMA reinforcement in the columns and capping beam for the best resistance to the earthquake response. Data used for simulations were obtained from the bridge components. It was observed that SMA has a high resistance to seismic loads when combined with steel reinforcement and it is therefore recommended for inclusion in reinforced concrete bridges to serve as means of reducing the effect of earthquakes on structures in earthquake prone areas.

Highlights

Google Scholar

Keywords

Main Subjects


[1]      Shin M. Seismic retrofit and repair of reinforced concrete bridge columns using shape memory alloy spirals 2012.
[2]      Emmanuelle O. Scaled Based Reinforced Concrete Framed in Smart Structural Materials on Spectral Ordinate. Epistemics Sci Eng Technol 2013;3:233–51.
[3]      Li H, Huo L. Advances in Structural Control in Civil Engineering in China. Math Probl Eng 2010;2010:1–23. doi:10.1155/2010/936081.
[4]      Rogers CA. Introduction to smart materials and structures. Smart Mater Struct Math Issues 1989:17–28.
[5]      R. Asim. Smart Memory Alloys. Proceeding Int Conf Adv Mech Eng 2012:18–120.
[6]      Duerig TW, Melton KN, Stöckel D. Engineering aspects of shape memory alloys. Butterworth-Heinemann; 2013.
[7]      Borden T. Forming a Tight Fit. Mech Eng 1991;113.
[8]      Fugazza D. Use of shape-memory alloy devices in earthquake engineering: Mechanical properties, advanced constitutive modelling and structural applications. PhD, Univ Degli Stud Di Pavia 2005.
[9]      Unjoh S, Tamakoshi T, Ikuta K, Sakai J. Damage Investigation of Matsurube Bridge during the 2008 Iwate-Miyagi-Nairiku Earthquake. Proc. 41st Jt. Meet. US-Japan Panel Wind Seism. Eff., 2009.
[10]    EN BS. 2: 2005 Eurocode 8: Design of Structures for Earthquake Resistance–Part 2: Bridges. Eur Comm Stand Brussels 2005.
[11]     BS 5400: Part 2, Steel Concrete and Composite Bridges, Part 2, Specification for loads 1978.
[12]    BS 8110-1:, Structural use of concrete – Part 1: Code of Practice for design and construction 1997.